Kipc India Pvt. Ltd supplied all pipes Installtion sevice, we have authorized dealer. (Yogendra Kumar Singh- Contact us: +919810599480).
Chiller line in HDPE pipe primarily intended for the transportation of hot or cold water and sewage either buried or above grade. It is also used in HDPE Pipe for chiller line and cooling tower.
All Type of molded fittings and fabricated fittings shall be fully pressure rated to match the pipe SDR pressure rating to which they are made. All HDPE Chiller line fittings shall be molded or fabricated by the manufacturer.
All Type of transition from HDPE pipe to ductile iron or PVC shall be made per the approval of ASPA Engineer and the HDPE pipe manufacturer’s recommendations and specifications to chiller line. It’s an HDPE mostly used in industrial pipe services.
High-Density Polyethylene pipes/fittings shall be allowed for use as water, wastewater and reclaimed water pressure pipe where compatible with the specific conditions of the project. The use of a material other than HDPE pipe may be required by ASPA if it is determined that HDPE pipe is unsuitable for the particular application. All material used in the production of water main piping shall be approved by the National Sanitation Foundation.
Chiller Fittings.
All molded fittings and fabricated fittings shall be fully pressure rated to match the pipe SDR pressure rating to which they are made. All fittings shall be molded or fabricated by the manufacturer. No Contractor fabricated fittings shall be used unless approved by the Engineer.
The manufacturer of the HDPE pipe shall supply all HDPE fittings and accessories as well as any adapters and/or specials required to perform the work as shown on the Drawings and specified herein.
All fittings shall be installed using butt-fused fittings, thermo-fused fittings/couplings, or flanged adapters and must be approved by the Engineer. NO size on size wet taps shall be permitted.
All transition from HDPE pipe to ductile iron or PVC shall be made per the approval of ASPA Engineer and per the HDPE pipe manufacturer’s recommendations and specifications. A molded flange connector adapter within a carbon steel back-up ring assembly shall be used for pipe type transitions. Ductile iron back-up rings shall mate with cast iron flanges per ANSI B16.1. A 316 stainless steel back-up ring shall mate with a 316 stainless steel flange per ANSI.
The transition from HDPE to ductile iron fittings and valves shall be approved by the ASPA Engineer before installation.
Advantages
1) Lowest installed cost
2) Less plant space than P/S
3) Easy to Control & Operate
4) Easy to Commission
Disadvantages
Highest Plant Energy Cost.
No comments:
Post a Comment